W116 450SEL radiator A1165012601: overheating & buyer's guide
Share
In summer the temperature gauge climbs well above 100 °C at the traffic light, on the highway everything is normal again, and somewhere coolant slowly disappears: with this picture many owners of a W116 450SEL go looking for the cause. Especially on the big V8 models, the cooling system works close to its limit – a radiator that delivers only part of its performance after decades is the first thing to show it. This guide shows how to narrow down the radiator as the cause and what to look for when replacing it.
Symptoms
| Symptom | Likely cause |
|---|---|
| Temperature rises when idling and in stop-and-go, normal when driving | Radiator core clogged or fan/viscous fan clutch without effect |
| Radiator core cold in places with the engine warm | Tubes clogged inside (limescale, deposits) |
| Greenish or white crusts on the core or the tanks | Leaking solder seam or corroded-through fins |
| Coolant loss, leak at the bottom front at the water pump | Not the radiator but the water pump – see our guide Water pump leaking |
| Engine never really warms up | More likely the thermostat is stuck open – not a radiator problem |
Causes
A radiator from the 1970s has usually been through many coolant changes – and often also periods with too little antifreeze or with tap water. Limescale and corrosion products deposit in the thin tubes. Every clogged tube drops out of the cooling, until the reserve is no longer enough for hot days and city traffic.
On the outside, road salt, stone chips and moisture attack the fins. They become brittle, break away or lie flat, so less air flows through the core. Added to this are stresses from many heat cycles, which wear on solder seams and connections. A radiator therefore rarely fails suddenly – it loses performance gradually over the years.
Testing it yourself
- Check coolant level and condition (cold engine): If the coolant is cloudy, rust-brown or full of particles, expect deposits in the radiator as well.
- Visual inspection of the core: Look at the fins with a flashlight – note flattened or crumbling areas and crusts at solder seams and tanks.
- Feel the temperature distribution (engine warm, beware of the fan and hot parts): The core should be evenly warm. Cold zones point to clogged tubes.
- Rule out fan and thermostat: Does the fan noticeably draw air with the engine warm? If the upper radiator hose gets hot, the thermostat is opening.
- Pressure test: A pressure test of the cooling system shows leaks that are not visible at standstill.
Solution
If the radiator is confirmed as the cause, replacing it with a genuine radiator is the cleanest solution. For the W116 450SE, 450SEL and 450SEL 6.9 we offer a genuine Behr radiator with the Mercedes part number A 116 501 26 01 . The radiator is used and in working order and shows age-related signs of wear; the protective grille may need to be replaced. Price: 449,00 €.
When installing, it is advisable to flush the cooling system thoroughly, check hoses and clamps and fill with fresh coolant in the correct mixing ratio – otherwise the buildup starts all over again in the new radiator. This is a one-off item and you will find more parts for your vehicle in our category Mercedes W116 spare parts.
Behr radiator W116 450SE / 450SEL / 450SEL 6.9
Part number: A 116 501 26 01 (A1165012601)
449,00 €
View radiatorCompatible vehicles
| Model series | Model | Part number |
|---|---|---|
| W116 | 450SE | A1165012601 |
| W116 | 450SEL | A1165012601 |
| W116 | 450SEL 6.9 | A1165012601 |
Please compare the part number with your installed radiator before buying. Other W116 engine variants are not documented in our product data. If you are thoroughly overhauling the 450SEL 6.9 anyway, you will also find a guide with us on the piston set for the 450SEL 6.9.
FAQ
What is the part number of the radiator for the W116 450SEL 6.9?
The genuine Behr radiator offered here carries the Mercedes part number A 116 501 26 01 (A1165012601). According to the product data, it fits the W116 450SE, 450SEL and 450SEL 6.9.
How do I tell that the radiator is the cause of overheating?
Typical signs are a cold or unevenly warm radiator core with the engine warm, wet or crusted spots on the core and at the solder seams, and coolant loss without a visible leak at the hoses or water pump. Thermostat, fan and water pump should be ruled out beforehand.
Can an old radiator be flushed instead of replaced?
Light deposits can be partly flushed out. If the core is badly clogged inside, corroded outside or leaking at the solder joints, flushing usually brings no lasting improvement. In that case a tested genuine radiator is the more sensible solution.
What condition is the radiator on offer in?
It is a used, working genuine Behr radiator with age-related signs of wear. The protective grille may need to be replaced. You will find details and pictures on the product page.
How much does the radiator A1165012601 cost?
The genuine Behr radiator A1165012601 costs 449,00 €. It is a one-off item; if it is sold, you will find more parts for the W116 in our W116 category.
KFZTeile-Thot is a specialist business for tested and refurbished Mercedes parts with its own test benches and over 1,000 positive eBay reviews. Not sure whether the radiator fits your car? Call us at +49 179 8991069 (Mon–Fri 8 am–6 pm) or write to us via the contact form.