Mercedes W114 W115 Kühlerversteifung Frontmaske A1156200972 NOS

W114 W115 Radiator Support A1156200972 – Buying Guide /8

Short answer: If the front panel of your first-series /8 (W114/W115) has rusted through or been warped by front-end damage, a new radiator support is often the cleaner route than patching large areas. The original part number for the models up to 1973 is A1156200972 (A 115 620 09 72). We currently have 13 uninstalled NOS parts, factory-primed, at 429,00 €. A different number applies to the 280 models and the second series.

Anyone restoring a Mercedes /8 will sooner or later reach the radiator support at the front end – the panel behind the grille that carries the hood latch, radiator and grille. Searching for “W115 front panel” or “/8 latch carrier”, however, turns up parts with different numbers, and not every one fits every model. This buying guide shows how to recognize damage on the old panel, how to determine the right version for the first series, and what to look for when buying.

Mercedes W114 W115 /8 Radiator Support Front Panel A1156200972, NOS Primed

How do you recognize wear or damage?

A sheet-metal part does not wear out like an electrical component. After about five decades, however, typical findings appear on the front panel of a /8:

Finding Meaning
Rust blisters or rust-through at seams and corners behind the grille Moisture and dirt collect behind the grille – with deep rust, consider replacing the radiator support
Panel gaps at grille and hood are uneven Indication of earlier front-end damage; the panel may be warped
Hood does not close cleanly or rattles Hood latch mount deformed or rusted – check adjustment and latch first
Filler or weld seams in the front area Earlier repair; the condition under paint and underbody coating is unclear
Engine overheats or loses coolant Not a case for the radiator support – this concerns the cooling system, see W116 radiator A1165012601: overheating (different model series, but same inspection procedure)

Causes

The front panel sits directly in the airstream. Stone chips break the paint and primer, splash water and road salt get behind the grille, and moisture dries poorly at seams and spot welds. Over decades, rust works its way from the inside out. On top of that come parking dings and accidents, which on a car of this age were often only repaired superficially. During restoration it often only becomes clear after stripping how much load-bearing material is left.

What to look for when buying

  1. Compare the part number: According to the Mercedes parts catalog, A1156200972 is listed for the first-series models up to 1973: 230.6, 250, 250 C, 250 CE, 200, 220, 200 D and 220 D. Compare the number with your old part or your VIN.
  2. Clarify series and engine: For 280, 280 E, 280 C, 280 CE, the 250 2.8 and the second series from 1973 (230.4, 240 D, 240 D 3.0), the catalog lists A 114 620 09 72. A panel “for W115” without series and model information is no proof of fit.
  3. Genuine or aftermarket: With a body part of this size, fit accuracy determines the installation effort. Our parts are genuine Mercedes new old stock (NOS) from old inventory, not aftermarket.
  4. Condition of the primer: The parts are factory-primed in black, without topcoat. Light storage marks are normal; it will be sanded before painting anyway.
  5. Plan for the scope of delivery: Only the sheet-metal part is supplied – without hood latch, grille and mounting hardware. You transfer these parts from your vehicle or source them separately.

Solution

If the old front panel of your first-series /8 is badly rusted or warped, a new genuine radiator support with the part number A1156200972 replaces the sheet-metal work on one of the most visible areas of the car. We currently have 13 uninstalled new Mercedes parts (NOS) in stock, each at 429,00 € per piece. One example is pictured. If you drive a 280 model or a second-series car, you need version A1146200972, which we also have in stock (590,00 €). The front panel of the W116 S-Class 300 SD is a different part – there is a separate guide for it: W116 300 SD Radiator Support A1166200672. You can find more parts in our category Other spare parts.

Genuine Mercedes-Benz W114 W115 Front Panel A1156200972 NOS, First Series /8 First Series – A1156200972Genuine Mercedes-Benz · NOS, factory-primed · 13 pcs in stock · 429,00 € per pieceView product
Mercedes W114 W115 Radiator Support A1146200972 for 280 Models and Second Series 280 Models / Second Series – A1146200972Different version, not for the first series · NOS · 590,00 € per pieceView product

Compatible vehicles

Model series Model (type) according to product data
/8 series W114 sedan, 1st series until 1973 230.6 (114.015, 114.017), 250 (114.010)
/8 series W114 coupe, 1st series until 1973 250 C (114.021), 250 CE (114.022)
/8 series W115 sedan, 1st series until 1973 200 (115.015), 220 (115.010), 200 D (115.115), 220 D (115.110)
Does not fit according to the parts catalog 280, 280 E, 280 C, 280 CE, 250 2.8, 250 C 2.8, second series from 1973 (230.4, 240 D, 240 D 3.0) – A 114 620 09 72 applies here
Does not fit W123, W108

Please compare the part number with your vehicle before buying – we are happy to check this for free using your VIN. If the engine of the same car is also due for work, read the guide M115 Chain Tensioner A1150500911: Timing Chain Rattles.

FAQ

What is the part number of the radiator support on the first-series W114/W115?

According to the Mercedes parts catalog, the radiator support (front panel, latch carrier) for the /8 models W114/W115 of the first series up to 1973 has the part number A1156200972, also written as A 115 620 09 72 or 1156200972.

Does A1156200972 also fit a 280 E, 240 D or a second-series /8?

No. For 280, 280 E, 280 C, 280 CE, 250 2.8 and the second series from 1973 (230.4, 240 D, 240 D 3.0), the Mercedes parts catalog lists the number A 114 620 09 72. A1156200972 also does not fit the W123 and W108.

Is the radiator support the same as the radiator?

No. The radiator support is a body panel: the front closure of the front end, which carries the hood latch as well as the radiator and grille mounting. The radiator is the coolant-carrying component of the cooling system.

What is included in the scope of delivery of the front panel?

Only the factory black-primed sheet-metal part is supplied, without hood latch, radiator grille and mounting hardware.

Does the radiator support have to be painted before installation?

Yes. The part is only primed from the factory, without topcoat. The primer shows light storage marks and is sanded before painting as usual.

KFZTeile-Thot is a specialist business for tested and refurbished Mercedes parts with its own test benches and over 1,000 positive eBay reviews. Not sure whether A1156200972 fits your /8? Call us at +49 179 8991069 (Mon–Fri 8 am–6 pm) or write to us via the contact form.

Back to blog

Need help?