W124 cruise control not working? T/LLR control unit A1245455132 (M104)
Share
Short answer: If the cruise control in the Mercedes W124 280 E or 320 E (M104, HFM, without ASR) works only sporadically or not at all – sometimes depending on temperature – the combined cruise control/idle control unit A 124 545 51 32 (VDO 412.227/002/017) is a possible cause. After ruling out the brake light switch and throttle actuator, replacing it with a genuine VDO control unit with an identical number helps – from us as a used genuine part for 249,00 €.
Anyone driving a W124 with the six-cylinder M104 quickly runs into a problem when troubleshooting the cruise control: there is no classic cruise control actuator on the throttle linkage and no separate idle speed actuator on these engines. A single control unit, the T/LLR module, handles both tasks. It drives the electronic throttle actuator directly at the throttle valve. Many instructions online refer to older models with a separate cruise control amplifier – on M104 cars with HFM engine management that often leads in the wrong direction. This guide shows how to narrow down the T/LLR control unit A1245455132 and what to watch for when replacing it.
Symptoms
Because the control unit handles cruise control and idle control at the same time, it is important to distinguish it clearly from other components:
| Symptom | Likely cause |
|---|---|
| Cruise control works only sporadically or not at all | T/LLR control unit aged or connector/contacts in the passenger footwell corroded |
| Failures occur depending on temperature (e.g. only with a warm interior) | Typical of an aging control unit with a temperature-dependent fault |
| Cruise control switches off again immediately, brake lights behave oddly | Brake light switch – its signal switches off the regulation |
| Cruise control and idle both faulty | Throttle actuator or T/LLR control unit – check the throttle actuator first |
| Idle fluctuates on an older four-cylinder M102 or V8 with a separate idle actuator | Not to be confused with: there the separate idle actuator is usually the cause – see W201 190E idle surging? Check the M102 idle speed actuator |
| W124 300 E (M103) with cruise control failure | Not to be confused with: different technology with a separate cruise control unit – see W124 cruise control cutting out? Check control unit A0055450532 |
Causes
The control unit A1245455132 dates from 1992 to 1993 – our unit carries the date 22.10.92 on the label. The electronics are therefore over three decades old. Components on the board age through heat, constant temperature changes and vibration; this explains why faults often occur only sporadically or at certain temperatures.
Added to this is the installation location in the passenger footwell. Moisture from leaking door seals, clogged drains or wet floor mats can attack connectors and contacts over the years. A connector with poor contact behaves much like a defective unit – so a look at the connector and housing belongs at the start of every diagnosis.
Testing it yourself
Start with the cheapest steps. The first checks take only a few minutes:
- Check the brake light. Have someone check behind the vehicle whether the brake lights come on cleanly when you press the pedal and go off again when you release it. A faulty signal from the brake light switch interrupts the cruise control regulation.
- Clarify the equipment. Does your car have ASR? Then it has an E-Gas control unit rather than a T/LLR module, and this guide does not apply.
- Check the connector and installation location. In the passenger footwell, loosen the carpet or trim, locate the control unit, pull off the connector and check for moisture, verdigris or bent pins.
- Rule out the throttle actuator. Because the control unit drives the throttle actuator directly, the actuator can also be the cause. It should be checked before the control unit.
- Read the part number and do a swap test. Note the number on the label. Within the W124 there are several T/LLR numbers (124 545 52 32, 55 32, 56 32). A swap test with a unit of identical number is the most reliable confirmation.
Solution
If the suspicion is confirmed, the control unit is replaced: disconnect the battery, pull off the connector, release the unit with its bracket and fit the replacement in the same position. We have a genuine VDO control unit A 124 545 51 32 (VDO 412.227/002/017) in stock – a used genuine part with a matte, clean housing, straight connector pins and a fully legible label (with one adhesive mark). It is supplied with the bracket, without the mating connector.
T/LLR control unit A1245455132 – cruise control & idle control
VDO 412.227/002/017 · Genuine Mercedes part · with bracket
W124 280 E / 320 E, M104 with HFM, without ASR · One-off
249,00 €
View control unitThis control unit is a one-off. If it has already been sold, you will find more tested control units in our category Mercedes relays & control units as well as all parts for the E-Class under W124.
Compatible vehicles
The overview reflects only what's documented for this part.
| Model series | Models | Note |
|---|---|---|
| E-Class W124 sedan (1992–1993) | 280 E (145 kW / 197 PS), 320 E (162 kW / 220 PS) | only M104 with HFM engine management, without ASR |
| W124 with ASR | does not fit | an E-Gas control unit is installed there (e.g. 124 545 62 32) |
| W124 400 E / 500 E (M119) | does not fit | own T/LLR and E-Gas numbers |
| Models with M103 | does not fit | separate cruise control amplifier |
What counts is always the number on your removed control unit. We are happy to check the fit using your VIN (chassis number).
FAQ
What functions does the control unit A1245455132 have in the W124?
It is a combined cruise control and idle control unit (T/LLR) from VDO. It regulates both the set speed and the idle speed, and for this it drives the electronic throttle actuator directly at the throttle valve.
Where is the cruise control unit located on the W124 280 E and 320 E?
The control unit is installed in the passenger footwell. There you can also read the part number on the label and compare it with the replacement part.
Does the control unit also fit a W124 with ASR?
No. Vehicles with ASR have an E-Gas control unit instead of the T/LLR module, for example 124 545 62 32. The two versions are not interchangeable.
Does A1245455132 fit the 400 E or 500 E?
No. The 400 E and 500 E models with M119 have their own T/LLR and E-Gas numbers. The control unit is documented for the W124 280 E and 320 E with M104 and HFM engine management without ASR.
How much does the cruise control unit A1245455132 cost?
The used genuine VDO control unit A1245455132 costs 249,00 Euro. It is supplied with the bracket but without the mating connector. It is a one-off, and the photos show exactly this part.
KFZTeile-Thot is a specialist business for tested and refurbished Mercedes parts with its own test benches. Control units, relays and instrument clusters are our focus – over 1,000 positive eBay reviews reflect that. Not sure whether your W124 has a T/LLR module or an E-Gas control unit? Call us at +49 179 8991069 (Mon–Fri 8 am–6 pm) or write via our contact form – fastest with the VIN and the number of your control unit.
